Force Table Demonstration

 

This demonstration is about vector addition.

Force Table        Motion Sensors

Used in Lab:

This  item is used in lab experiments for PHYS 115.

Equipment:

Setup Instructions:

  • Screw the table onto the stand rod, and the rod onto the base
  • Put the pin in the top, and put the ring on it
  • Put the three pulleys on the rim of the table at the desired angles
  • Hang the mass hangers and weights until the ring is centered around the pin
  • Optional: Plug in LoggerPro and connect two force probes.

Apparatus Notes:

If you keep two force probes connected at 0 and 90 degrees, it will be a fair measure of the x and y components of the hanging mass vector.


Safety Information: None.
JHA